Concrete and masonry cleaner

SEAL-ONCE® Concrete/Masonry Cleaner prepares concrete surfaces for the application of SEAL-ONCE concrete and masonry coatings. The concentrated formula penetrates the surface to loosen dirt and remove discoloration, oil, grease, mold and mildew stains without the use of harsh chemicals. It restores the original color of the concrete and masonry, making it look like new.

Recommended Use:

Docks Piers  Patios Walkways and steps Stamped and poured concrete Pavers Bricks Mortar and grout Unglazed tile Stucco

Features & Benefits

• Eco-friendly, Biodegradable, Soap & water cleanup
• Non-toxic; will not harm pets, plants or people
• Zero chlorine, bleach & phosphates
• A 2 lb container will make 8 gallons for a total of 4,000 to 6,000 sq ft.
• 1 gallon will cover 500-800 sq. ft
• Removes discolouration and brightens concrete
• Removes mould, mildew & fungi stains

• All surfaces should be dry for best penetration and performance.
• Remove any furniture and fixtures from area to be cleaned. Clear all dust, debris and loose material from surface.

• Add ½ cup of powder per gallon of water. Stir thoroughly to ensure all powder has dissolved.
• Allow the prepared solution to sit for 15 minutes to fully activate prior to use.
• Apply to all dry concrete or masonry surfaces using a pump-up garden sprayer.
• Allow cleaner to sit on the surface for 30 minutes before rising off thoroughly using a garden hose or pressure washer.
• For best results, do not apply in direct sunlight or on hot surfaces. If surface becomes dry, mist with water to reactivate cleaner.
• Do not apply to surfaces that have been sealed with SEAL-ONCE products.
• Once the concrete or masonry has been cleaned, rinsed and has dried completely, SEAL-ONCE products can be applied.
• Remove excess stain sitting or puddling on the surface. Back brush or use a rag to wipe away any runs, drips, or puddles that have not soaked in.

• Allow approximately 4-6 hours for surface to dry completely, depending on temperature and humidity, before applying SEAL-ONCE sealers.
• For best results, allow 12-24 hours for surface to dry.
• Clean sprayer equipment, sponges and brushes with warm soapy water.
• Disposal: soap and water cleanup; no special disposal procedure needed.

• Do not use SEAL-ONCE Concrete/Masonry Cleaner on surfaces that have been sealed or stained with SEAL-ONCE products as it will remove the product and require the surface to be resealed.
• Surfaces that have been treated with SEAL-ONCE can be cleaned using a mixture of 1 gallon warm water, 14 oz. bleach, and 1 oz. of Dawn® dish detergent. Apply this cleaning solution with a sprayer and allow to sit for 20 to 30 minutes on the concrete surface before rinsing with water using a garden hose with a nozzle.
• This cleaning solution can be used to remove airborne mold and mildew stains, dirt and grime from the concrete or masonry. SEAL-ONCE will prevent and resist any water, mold and mildew penetration.